X Series E53 X5 4.4i (M62) OFFRD
1.
Retaining lugs (1) must be completely snapped into
place.
2.
Replace rubber seal on fuel level sensor.
3.
Fit rubber seal over fuel level sensor flange.
4.
Before pressing fuel level sensor into tank opening,
detach rubber seal from flange and insert into tank
opening.
Installation:
Replace O-ring (1) on fuel level sensor. Before fitting, apply a
light coat of engine oil to O-ring.
Check that O-ring is correctly seated when installed.
Connection of suction jet pump is transparent.
Important!
Comply with the following installation instruction without
fail.
Installation:
When installing fuel level sensor, comply with the following without
fail:
1.
Insert fuel level sensor flange (1) horizontally into tank
opening so that sensor foot (2) is positioned vertically in
recess (3) in bottom of fuel tank.
2.
Press fuel level sensor flange into tank opening.
3.
Fuel level sensor flange must remain in pressed-in position!
When the flange is partially pressed out, the sensor foot (2) is
not in the recess (3) in the bottom of the fuel tank.
4.
Line set (5) must not interlock with sensor arm (4).
RA Removing and installing/replacing fuel gauge sensor (left)
BMW AG - TIS
08.02.2013 03:21
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
