X Series E53 X5 4.4i (M62) OFFRD
Support transmission and transfer case with special tools
00 2 030 / 24 5 301 / 24 0 250 .
Unclip oxygen sensor cable from transmission cross-member.
Unclip cable from transmission.
Unfasten screws and remove transmission cross-member.
Installation:
Tightening torque, 27 00 10AZ.
Unfasten screws.
Installation:
Replace self-locking nuts.
When tightening screws down: Grip each screw and tighten
down nut. This prevents the flexible disk from being subjected
to torsion stress.
Tightening torque, 26 11 1AZ.
Brace propeller shaft on center bearing and loosen nuts.
Installation:
Center bearing must be aligned at right angles to propeller
shaft.
Tightening torque, 26 11 6AZ.
RA Removing and installing automatic transmission (A5S 440Z)
BMW AG - TIS
08.02.2013 03:56
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
