bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

8 RA Removing And Installing Vane Pump_power Steering Pump For Power Steering (LUK)|Page 1292 > < 7 RA Checking Function Of Power Steering Vane Pump|Page 1290
Page 1
background image

32 41 060

Removing and installing vane pump/power
steering pump for power steering (LUK)

Important!

Adhere to the utmost cleanliness. Do not allow any dirt to
enter the system.

Seal off pipe connections with plugs.

After installation:

Fill and bleed hydraulic system. Check pipe connections for

leaks.

Necessary preliminary tasks:

Draw off and dispose of hydraulic fluid

Observe country-specific waste-disposal regulations.

Remove underbody protection

Remove drive belt

Release banjo bolt (1).

Installation:

Tightening torque 32 41 3AZ

.

Replace seals (D).

Loosen screws (2).

Release banjo bolt (3).

Installation:

Tightening torque 32 41 3AZ

.

Replace seals (D).

Release nut (4) and remove power steering pump.

Installation:

Tighten down front screws.

Tighten knurled nut (5) hand-tight.

RA  Removing and installing vane pump/power steering pump for power steering (LUK)

BMW AG - TIS

08.02.2013  05:56

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

8 RA Removing And Installing Vane Pump_power Steering Pump For Power Steering (LUK)|Page 1292 > < 7 RA Checking Function Of Power Steering Vane Pump|Page 1290