X Series E53 X5 4.4i (M62) OFFRD
34 32 861
Replacing all brake pipes
Special tools required:
•
34 5 100
Note:
Brake pipes are only supplied straight, in correct length and
fitted with connecting nipples.
Caution!
Read and comply with General Information.
The rear brake hoses are secured on the upper control arms
by line holders. The flaps of the line holders must not be
opened. If this does however occur, the holders must be
replaced.
After finishing work:
Bleed brake system.
New brake lines must be bent as required using bending tool
34 5 100 .
Removed brake pipes can be used as templates for bending.
Caution!
-
Protective coat on brake pipes must
not be damaged while bending.
-
Brake pipes must not be bent back and
forth.
-
Watch distances to fixed and movable vehicle parts.
Brake lines may not contact or rub.
-
Tighten brake-pipe couplings
with torque wrench.
Tightening torque:
Refer to Technical Data.
RA Replacing all brake pipes
BMW AG - TIS
08.02.2013 06:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
