X Series E53 X5 4.4i (M62) OFFRD
36 11 533
Removing and installing / replacing RDC
wheel electronics
Note:
If a tyre sealant has been used, replace the wheel electronics.
When a tyre has been removed, do not clean the rim with installed
wheel electronics with high-pressure cleaning equipment.
Do not treat wheel electronics with solvents, cleaning agents etc. If
dirty, wipe with a clean cloth only.
Do not clean wheel electronics with compressed air.
Important!
If the wheel electronics have been removed, the complete
valve must be replaced.
Necessary preliminary tasks:
•
Remove tyre
Follow instructions on initializing Run Flat Indicator.
Labelling of wheel electronics
1
Transmitting frequency of wheel electronics
2
Large Torx socket
3
BMW part number
4
Tightening torque of Torx screw and union nut
5
Width across flats of union nut
6
Identification code of wheel electronics
7
Date of manufacture of wheel electronics
RA Removing and installing / replacing RDC wheel electronics
BMW AG - TIS
08.02.2013 07:29
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -