X Series E53 X5 4.4i (M62) OFFRD
Mark partition wall, assembly compartment, according to
illustration, cut (1) and open weld seams (2) to wheel arch
support.
A = 60 mm
B = 180 mm
C = Center, hole
D = Center, radius
Open welding spots (1) on wheel arch supports to engine carrier
shell, exterior and interior.
Note:
Adhere to following severance cut otherwise reinforcement of
engine carrier will be cut.
Mark cutting line on wheel arch support and cut up to wheel arch
support.
A = 140 mm from firewall cross-member
B = 200 mm from edge of bore on engine carrier
(measured parallel to lower edge of engine carrier)
RA Replacing left front engine carrier (without wheel housing) (partial replacement
BMW AG - TIS
08.02.2013 08:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -