bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

3 RA Adjusting Jet Nozzle For Rear Window Washer Unit > < 1 RA Replacing Wiper Arm For Rear Window Wiper|Page 2462
Page 1
background image

61 62 060

Removing and installing / replacing rear
window wiper motor

Remove panel for rear lid upper section at bottom.

Remove wiper arm for rear wiper.

Note:

Secure rear window wiper motor against falling out.

Disconnect plug connection (1) and release screws (2).

Remove rear window wiper motor (3).

Installation:

Insert screws (2) and tighten until hand-tight.

Center rear window wiper motor (3) and tighten down
screws (2).

Observe tightening torque, 61 62 1AZ.

Installation:

Replace rubber grommet (1).

Note installation position of rubber grommet (1) (marking
must be in horizontal position).

RA  Removing and installing / replacing rear window wiper motor

BMW AG - TIS

08.02.2013  13:24

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

3 RA Adjusting Jet Nozzle For Rear Window Washer Unit > < 1 RA Replacing Wiper Arm For Rear Window Wiper|Page 2462