X Series E53 X5 4.8is (N62-S) OFFRD
The support sleeve (2) remains in the radial shaft seal and is
used as a slip sleeve in the installation described later.
Important!
Special tool 11 2 390 must not be used.
When the radial shaft seal is installed, only the support sleeve
included in the scope of delivery may be used as a slip sleeve.
Note:
The radial shaft seal can only be replaced completely with the end
cover.
The gasket is an integral part of the end cover and cannot be
replaced individually.
Installation:
Check dowel sleeves (1) for damage and correct installation
position.
Keep sealing faces clean and free of oil.
Coat contact points on joint along oil sump with Drei Bond 1209
(refer to BMW Parts Service).
Installation:
Lightly oil running surface of crankshaft.
Fit end cover (1) with support sleeve (2) on crankshaft and push
on carefully.
RA Replacing crankshaft radial shaft seal (N62 / N62TU)
BMW AG - TIS
12.02.2013 03:58
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
