X Series E53 X5 4.8is (N62-S) OFFRD
Attach special tool 11 9 490 to second end of torsion spring.
Support end of torsion spring protected with special tool
11 9 490 on inlet camshaft.
Installation
Removal of intermediate levers is described separately from
installation.
Clean all bearings and cams of inlet camshaft and lubricate with
engine oil.
Important!
Intermediate levers (2) are divided into individual tolerance
classes.
Only intermediate levers of the same tolerance class may be
fitted in a single cylinder head.
The tolerance classes are designated as illustrated with the
numbers from 1 to 5.
Used intermediate levers (2) may only be reused in the same
position.
Lubricate all sliding surfaces on intermediate lever (2) with
engine oil.
Raise torsion spring (1) with special tool
11 9 480 .
Detach special tool 11 9 490 .
RA Removing and installing/replacing left intermediate lever (N62 to 9/03)
BMW AG - TIS
12.02.2013 04:15
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -
