X Series E53 X5 4.8is (N62-S) OFFRD
Place bearing bracket (1) with inlet camshaft and eccentric shaft
as illustrated on special tool 11 9 470 .
Secure bearing bracket (1) with a nut (special tool 11 9 473 ).
Important!
The lower section of the bearing bracket (1) is machined with
the cylinder head and must not be mixed up.
Note:
Lower section of bearing bracket (1) remains on cylinder head.
Note:
The mounting of the bearing bracket described later can only be
carried out if the inlet camshaft has not been axially displaced.
Special tools 11 9 472 and 11 9 475 prevent the inlet
camshaft from rotating and moving while the intermediate levers
are installed.
Fit special tool 11 9 472 and secure with special tool
11 9 475 .
Insert special tool 11 9 474 and initially tighten without play.
RA Removing and installing/replacing right intermediate lever (N62 to 9/03)
BMW AG - TIS
12.02.2013 04:16
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
