X Series E53 X5 4.8is (N62-S) OFFRD
Important!
Intermediate levers (2) are divided into individual tolerance
classes.
Only intermediate levers of the same tolerance class may be
fitted in a single engine.
The tolerance classes are designated as illustrated with the
numbers from 1 to 5.
Used intermediate levers (2) may only be reused in the same
position.
Lubricate all sliding surfaces on intermediate lever (2) with
engine oil.
Raise torsion spring (1) with special tool
11 9 480 .
Remove special tool 11 9 490 .
Hold torsion spring (1) with special tool
11 9 480 .
Install intermediate lever (2) from above.
Insert end of torsion spring (1) into guide on intermediate
lever (2).
Raise second end of torsion spring with special tool 11 9 480 .
Remove special tool 11 9 490 .
RA Removing and installing/replacing left inlet camshaft (N62 from 9/03 and N62TU)
BMW AG - TIS
12.02.2013 04:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 11 -
