X Series E53 X5 4.8is (N62-S) OFFRD
11 36 720
Removing and installing/replacing both right
solenoid valves (N62/N62TU)
(cylinder bank 1 to 4)
Necessary preliminary tasks:
•
Read out fault memory of control unit of Digital Motor
Electronics (DME)
•
Switch off ignition
•
Remove acoustic cover
•
Remove design cover
•
Remove upper section of intake filter housing with air-mass
flow sensor and intake hose
Note:
Solenoid valve (1) controls adjustment unit on inlet side.
Solenoid valve (2) controls adjustment unit on exhaust side.
Unlock plug of solenoid valves (1 and 2) and disconnect.
Release screws and remove holder (3).
Pull out solenoid valves (1 and 2).
Installation:
Check holder (3) for deformation; replace if necessary.
Installation:
Clean sealing faces (1) on cylinder head.
RA Removing and installing/replacing both right solenoid valves (N62/N62TU)
BMW AG - TIS
12.02.2013 04:26
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
