X Series E53 X5 4.8is (N62-S) OFFRD
Installation of magnet wheel:
Note:
Carefully clamp eccentric shaft (1) as illustrated with protective
jaws (2) in a vice.
Important!
Incorrect assembly will result in engine damage.
Assembling eccentric shaft for cylinder bank 5 to 8:
The machined curvature (3) and the groove in the eccentric shaft
must point forwards as illustrated.
The unmachined surface on the eccentric points to the left.
Secure magnet wheel (1) with lug in eccentric shaft groove.
Important!
Only install original antimagnetic screw (2).
Insert screw (2) and tighten down.
Tightening torque 11 37 1AZ
.
Note:
Replace bearing shells (1) of needle bearings.
Important!
Bearing shells (1) must be installed in such a way that ends
of bearing shells (1) face each other as shown in illustration.
Insert bearing shells (1) into bearing bracket so that it is secured
in bore (2).
RA Removing and installing/replacing left eccentric shaft (N62 from 9/03 and N62TU)
BMW AG - TIS
12.02.2013 04:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
