X Series E53 X5 4.8is (N62-S) OFFRD
11 66 000
Removing and installing/replacing vacuum
pump (N62/N62TU)
Note:
Press brake pedal several times in order to reduce vacuum
pressure in brake booster.
Installation location:
Vacuum pump is fitted on cylinder head 1 to 4 at front on
exhaust camshaft.
Remove design cover.
Remove acoustic cover.
Remove intake hose with air-mass flow sensor and upper section
of intake filter housing.
Important!
Installation:
Due to the risk of damage to the engine gaskets/seals and the
lack of brake boosting, make sure before starting the engine
that all the vacuum lines are connected.
Open hose clip (1) and pull off vacuum line.
Release nuts on hose holders.
Remove vacuum hose.
Release screws and remove holder (1).
Remove vacuum pump (2).
RA Removing and installing/replacing vacuum pump (N62/N62TU)
BMW AG - TIS
12.02.2013 04:43
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
