X Series E53 X5 4.8is (N62-S) OFFRD
Release control sensor (2) with special tool 11 7 030 .
Installation:
Threads of new oxygen sensors are already coated with
Never Seez Compound.
If the oxygen sensor is reused, only apply a thin and uniform coat
of Never Seez Compound (refer to BMW Parts Service) to
thread.
Oxygen sensor section projecting into exhaust system branch
must not be cleaned or come into contact with lubricant.
Installation:
Tighten down control sensor (2) with special tool 11 7 030 .
Tightening torque 11 78 1AZ
.
Pay attention to cable routing of control sensor.
Installation:
Different heat shields!
To prevent fraying, make sure that wiring harness (1) is correctly
laid on heat shield (2).
RA Replacing right oxygen control sensor (N62/N62TU)
BMW AG - TIS
12.02.2013 04:50
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
