X Series E53 X5 4.8is (N62-S) OFFRD
Important!
Do not let propeller shaft fall into joints.
Joints and rubber sleeve on constant-velocity joint can be
damaged.
Brace propeller shaft on center mount and loosen nuts.
Tightening torque, 26 11 6AZ .
Bend propeller shaft downwards on center bearing.
Remove propeller shaft from transmission output flange and
remove constant-velocity joint from final drive.
Note:
Protect constant-velocity joint from dirt with transport cap.
Installation:
Top up grease fill.
Grease:
Refer to BMW Service Operating Fluids.
Pull out constant-velocity joint (1) up to stop.
Coat sealing faces of constant-velocity joint and input flange
with grease.
Replace seal (2).
Use new nuts.
Attach propeller shaft with constant-velocity joint pulled apart
to drive flange of final drive.
RA Removing and installing complete propeller shaft
BMW AG - TIS
12.02.2013 05:56
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
