X Series E53 X5 4.8is (N62-S) OFFRD
27 10 010
Removing and installing ATC 500 X-Drive
transfer box (automatic transmission)
Important!
After replacement, the "Repair" service function must be
carried out with GT1.
Important!
After completing work, check gear oil level and top up if
necessary.
Filler plug (1):
Tightening torque 27 00 11AZ
.
Oil level up to filler edge of filler plug (1).
Use only the approved transmission fluid.
Failure to comply with this requirement will result in serious
damage to the transfer case!
Necessary preliminary tasks:
•
Remove catalytic exhaust-gas converter with centre muffler
(N62).
•
Remove complete exhaust system (M57TU).
•
Remove front and rear heat shields.
Grip clamping sleeve (1) and slacken nut (2).
Tightening torque 25 16 2AZ
.
Pull out retainer (3) using a screwdriver.
Installation:
Adjust selector lever.
RA Removing and installing ATC 500 X-Drive transfer box (automatic transmission)
BMW AG - TIS
12.02.2013 06:04
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
