X Series E53 X5 4.8is (N62-S) OFFRD
Important!
The section "Removing and installing reinforcement plate"
contains important installation instructions.
Remove reinforcement plate.
Remove front underbody protection.
Remove front propeller shaft.
Unfasten steering spindle from steering gear. This operation is
described in the section "Removing and installing hydraulic
steering gear".
Note:
Output shaft is not pressed out of drive flange.
Output shaft (1) and swivel bearing (2) remain together as a
single unit during removal and installation.
Remove left and right swivel bearings.
Remove output shafts.
RA Removing and installing / replacing front differential (M62, N62)
BMW AG - TIS
12.02.2013 06:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
