X Series E53 X5 4.8is (N62-S) OFFRD
31 53 040
Removing and installing / replacing right
output shaft bearing block
After installation:
•
Check front differential oil level, correct if necessary
Note on E53:
Output shaft is not pressed out of drive flange.
Output shaft (1) and swivel bearing (2) remain together as a
single unit during removal and installation.
Note on E46:
Remove cross-member from front axle carrier.
Output shaft is not pressed out of drive flange.
Swivel bearing (1), output shaft (2) and control arm (3) remain
together as a single unit during removal and installation.
Remove output shaft.
RA Removing and installing / replacing right output shaft bearing block
BMW AG - TIS
12.02.2013 06:37
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -