X Series E53 X5 4.8is (N62-S) OFFRD
31 60 000
Removing and installing left or right output
shaft
Special tools required:
•
31 5 110
Important!
Risk of damage!
Do not drive output shaft out of drive flange with an impact
tool.
Remove front wheel.
Release collar nut; to do so, press brake pedal to floor.
Installation:
Replace collar nut, apply a light coating of oil to contact surface
and tighten down.
Tightening torque 31 21 2AZ
.
Secure collar nut by peening on flat areas of output shaft.
Remove front assembly underside protection.
Remove reinforcement plate.
Remove pulse generator from swivel bearing.
Remove front brake caliper and tie up.
Remove tie rod end from swivel bearing.
Remove tension strut with guide joint from swivel bearing.
Remove control arm from swivel bearing.
Turn swivel bearing to one side.
Press output shaft out of drive flange.
RA Removing and installing left or right output shaft
BMW AG - TIS
12.02.2013 06:40
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
