X Series E53 X5 4.8is (N62-S) OFFRD
After mounting, first release clamps and then inflate tyre (without
valve).
Increase pressure up to 3.3 bar (330 kPa) in steps (jumping
pressure).
If the tyre bead does not slip on all round at the rim edge, do not
increase pressure further but rather drain off air.
Press off tyre bead again, coat rim flange again with tyre mounting
paste, refer to BMW Parts Service, and pump up again
to 3.3 bar. When the beads are resting properly on the rim
shoulders, increase inflation pressure to max. 4.0 bar to "settle"
the tyre.
Screw in valve insert and correct tyre pressure.
RA Changing a tyre (on front, rear or spare wheel)
BMW AG - TIS
12.02.2013 08:58
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
