X Series E53 X5 4.8is (N62-S) OFFRD
Note:
Scope of work for "Replacing handle strip (on rear lid after 09/01)"
ends here.
Handle strip after 09/01 on rear lid before 09/01:
Use repair kit.
Fit new (closed) expansion nuts (1).
Clean area of handle strip (grease-free).
Pull off round film (2) from liner (4) and seal left bore hole.
Pull off long film (3) from liner (4), seal right bore hole and both
elongated holes.
The liner is the protective film on the bonding area.
Attach seal (1) over plug connection (2) of new handle strip (3).
Seal (4) must not be damaged.
Use only new screws (3.5 x 13 mm).
Installation:
Perform function check with trunk lid open.
Note:
Scope of work for "Replacing handle strip after 09/01 on rear lid
before 09/01" ends here.
RA Replacing handle strip (on trunk lid)
BMW AG - TIS
12.02.2013 10:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
