X Series E53 X5 4.8is (N62-S) OFFRD
54 13 105
Removing and installing/replacing rear drip
moulding
Necessary preliminary tasks:
•
Remove complete glass slide/tilt sunroof
•
Remove glass slide/tilt sunroof lid at rear
Unlock tab (2) and remove drip moulding (1) towards top.
Note:
2 springs are loosely connected to guide for drip moulding.
Installation:
Make sure springs are reinstalled on drip moulding carriers.
Removing drip moulding carrier:
Note:
Drip moulding carrier cannot be removed without incurring
damage.
Break out tabs with a screwdriver and lever out carrier.
Installation:
Replace drip moulding carrier and hook into place.
RA Removing and installing/replacing rear drip moulding
BMW AG - TIS
12.02.2013 13:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
