X Series E70 X5 3.0Sd (M57T2) OFFRD
Unfasten cylinder head bolts from outside to inside in following
sequence 14 ... 1.
Installation:
Fit new cylinder head screws.
Important!
The glow plugs protrude at the sealing face and may be
damaged when the cylinder head is put down.
If necessary, remove glow plugs with special tool 11 6 050 .
Tightening torque 12 23 2AZ
.
Remove cylinder head.
Remove cylinder head gasket (1).
Installation:
Observe number of holes (2) of cylinder head gasket.
Remove all traces of oil and coolant from all tapped blind
holes (3) in crankcase.
Clean sealing surface (4).
Note:
Clean sealing face of cylinder head and engine block.
Remove gasket remnants with hardwood spatula.
If the piston clearance is changed (e.g. replacing piston)
the cylinder head gasket thickness must be recalculated.
RA Removing and installing cylinder head (M57T2)
BMW AG - TIS
05.02.2013 01:33
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -