X Series E70 X5 3.0Sd (M57T2) OFFRD
37 20 001
Removing and installing/replacing DYNAMIC
DRIVE valve block
Special tools required:
•
13 5 020
•
37 1 151
•
37 1 152
Warning!
Danger of poisoning if oil is ingested/absorbed through the
skin!
Risk of injury if oil comes into contact with eyes and skin!
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Note:
In a warranty case you must always provide a fault memory
printout, even where there is no fault memory entry, with the
defective part. In addition, the valve block openings must be
sealed with the protective caps (of the new part).
Necessary preliminary tasks:
•
Draw off and dispose of hydraulic fluid from fluid reservoir
•
Partially remove front right wheel arch cover (rear section)
•
Remove right underbody panelling
RA Removing and installing/replacing DYNAMIC DRIVE valve block
BMW AG - TIS
05.02.2013 10:01
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -