X Series E70 X5 3.0Sd (M57T2) OFFRD
51 47 ...
Removing and installing/replacing left or right
underbody panelling
Necessary preliminary tasks:
Underbody panelling must not be jammed by lifting platform. If
necessary, fit suitable blocks under vehicle jacking points.
Note:
Work shown on X5 3.0i by way of example, deviations in detail are
possible in other models.
Cover, side, six-cylinder models:
Release screws/nuts (1 and 2).
Feed out cover (3).
Installation:
Ensure cover (3) is correctly seated.
Underbody panelling, side:
Release clips (1).
Release screws/nuts (2 and 4).
Feed out underbody panelling (3).
Installation:
If necessary, replace faulty clips (1).
Fit clips (1) with O-rings.
Make sure underbody panelling (3) is correctly seated.
Underride protection, tank:
Release clips (1).
Release screws/nuts (2 and 3).
Feed out underride protection (4).
Installation:
If necessary, replace faulty clips (1).
Fit clips (1) with O-rings.
Make sure underride protection (4) is correctly seated.
RA Removing and installing/replacing left or right underbody panelling
BMW AG - TIS
05.02.2013 12:53
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -