X Series E70 X5 3.0Si (N52K) OFFRD
Installation:
When installing, do not damage shaft seal and bearing.
If the torque converter is not correctly installed, the driver of the
pump impeller may be damaged when the transmission is flanged
to the engine.
Remove torque converter and set down vertically.
Installation:
Push torque converter through shaft seal onto transmission shaft
as far as it will go.
Press torque converter by hand into converter housing and turn in
the process. Converter hub opening must snap into place in driver
of pump impeller. Torque converter must be felt to slip inwards.
Determine distance between contact surface and surface (1) of
tapped hole in torque converter with special tool 00 2 550 .
Note:
Measured value must be greater than 30 mm.
RA Removing and installing/replacing torque converter (GA6HP19Z)
BMW AG - TIS
06.02.2013 17:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
