X Series E70 X5 3.0Si (N52K) OFFRD
Switch on laser pointer (2) with knurled screw (1).
Align laser pointer first to zero point on scale (3), then upwards to centre of BMW badge (4).
In the event of a laser deviation from the BMW badge centre, this must be compensated for by shifting the complete
linkage in the corresponding direction.
After realigning the target, check the position of the laser again and correct if necessary.
Align contact surface (1) on both sides to tyre side wall.
Tighten linkage simultaneously on both sides with adjusting
screw (2).
Note:
After securing linkage, check position of laser pointer again on
vehicle's BMW badge.
If necessary, correct by means of adjusting screws.
RA Calibrating reversing camera
BMW AG - TIS
07.02.2013 05:20
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
