X Series E70 X5 4.8i (N62TU) OFFRD
12 51 001
Replacing wiring harness section for engine
(N62)
Necessary preliminary tasks:
•
Read out DME fault memory
•
Disconnect battery negative lead
•
Engine bonnet/hood in assembly position
•
Remove fresh air duct on right and if necessary on left
•
Remove center of assembly partition wall
•
Remove intake air manifold
•
Remove underbody protection at front/rear
•
Remove reinforcement plate
•
Remove electric fan with fan cowl
•
Remove right exhaust manifold
•
Remove starter motor
•
Remove alternator
Release screws (2).
Detach electronics box cover (1) from fixture (3) in direction of
arrow towards right.
Installation:
Secure electronics box cover (1) in direction of arrow on left in
fixture (3).
Unfasten following plug connections:
RA Replacing wiring harness section for engine (N62)
BMW AG - TIS
08.02.2013 00:56
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -