X Series E70 X5 4.8i (N62TU) OFFRD
Release nuts (1) and remove cover for service opening (2) from
left side of fuel tank.
Disconnect plug connection (1).
Unlock quick-release fastener (2) and detach fuel feed line.
Unlock quick-release fastener (3) for vent line and detach.
Measure gap dimension (A) at clamping ring (1).
Release hose clamp (2) and remove from clamping ring (1).
Press clamping ring (1) apart at open end and remove.
Installation:
Make sure that service cover is installed in correct position.
Indentation (2) on clamping ring must line up with raised
section (1) of tank.
Pin on service cover (3) must line up with indentation on
clamping ring.
Hose clamp (4) must always be replaced (pay attention to correct
position).
Tighten hose clamp until clamping ring gap dimension is obtained.
RA Removing and installing or replacing fuel gauge sensor (petrol/gasoline, left)
BMW AG - TIS
08.02.2013 01:27
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
