bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

3 RA Removing And Installing_replacing Fuel Pump (petrol_gasoline Vehicles)|Page 757 > < 2 RA Removing And Installing Or Replacing Fuel Gauge Sensor (petrol_gasoline, Left)|Page 755
Page 1
background image

16 14 010

Removing and installing/replacing fuel pump
(petrol/gasoline vehicles)

Recycling

Fuel escapes when fuel lines are detached. Have a suitable
collecting container ready.

Catch and dispose of escaping fuel.

Observe country-specific waste-disposal regulations.

Important!

Ensure adequate ventilation in the place of work!

Avoid skin contact (wear gloves)!

Ensure absolute cleanliness when working on the open fuel
tank.
Contaminants in the fuel tank can impair driving operation or
may even result in vehicle breakdown!

Before starting the engine for the first time:

Fill fuel tank with at least 5 litres of fuel

Check transfer function of suction jet pump.

Necessary preliminary tasks:

Draw off fuel from fuel tank

Remove rear seat bench

If necessary, disconnect plug connection (1).

Remove cover (2).

RA  Removing and installing/replacing fuel pump (petrol/gasoline vehicles)

BMW AG - TIS

08.02.2013  01:27

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

3 RA Removing And Installing_replacing Fuel Pump (petrol_gasoline Vehicles)|Page 757 > < 2 RA Removing And Installing Or Replacing Fuel Gauge Sensor (petrol_gasoline, Left)|Page 755