X Series E70 X5 4.8i (N62TU) OFFRD
31 21 180
Replacing bearing (wheel bearing) for front
wheel
Important!
Bearing cannot be dismantled.
Do not wash out bearing.
Remove front wheel.
Important!
Expand turning lock sufficiently sufficiently to avoid damaging
thread when releasing collar nut.
Release collar nut (1), press brake pedal to floor for this purpose.
Installation:
Replace collar nut, oil collar nut/wheel bearing contact surface
only and tighten down.
No oil permitted on thread of shaft journal or collar nut.
Tightening torque 31 21 2AZ
.
Secure collar nut by positive peening on flat areas of output shaft.
Remove brake disk.
Release screw (1) and pull pulse generator out of bore.
Installation:
Clean bore for pulse generator and lubricate with Staburags NBU
12/K grease.
Tightening torque 34 51 3AZ
.
Release screws (2) and remove holder from swivel bearing.
RA Replacing bearing (wheel bearing) for front wheel
BMW AG - TIS
08.02.2013 02:46
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
