X Series E70 X5 4.8i (N62TU) OFFRD
Important!
When installing output shaft, make sure that tripod does not
fall into gaiter.
Press swivel bearing slightly to one side and insert output shaft
into front differential.
Pull out assembly protection ring at lug (1) until one of the two
programmed rupture points gives.
Slide output shaft as far as it will go into front differential. Output
shaft must snap audibly into place.
Press swivel bearing slightly to one side and insert output shaft
into wheel bearing.
Move steering to straight-ahead position.
Draw output shaft into drive flange.
Install lower control arm.
Remove steering gear cover at top and bottom.
Install reinforcement plate.
Remove special tool 31 4 170 for swivel bearing (1).
Use plugs from spring strut dome.
Install left microfilter housing cover.
RA Removing and installing or replacing left output shaft
BMW AG - TIS
08.02.2013 03:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
