X Series E70 X5 4.8i (N62TU) OFFRD
32 00 155
KDS chassis/wheel alignment check with
ride-height measurement without load
Important!
Do not carry out chassis/wheel alignment without load:
A) If the technical preconditions for alignment with ride
height input are not in place
B) If, in spite of repairs having been carried out, the car's
ride height between the left and right sides is still outside
the tolerance
C) If the vehicles in question have been involved in an
accident
Note:
•
Read and comply with General information and definitions.
•
Read and comply with General chassis definition.
Note:
•
Check compliance with test conditions, bring vehicle to a stop
if necessary.
•
If the ride height is outside the tolerance range (+40/-20 mm),
the vehicle must be loaded and measured/aligned in the
design position.
•
Calibrate reversing camera (RFK) after chassis/wheel
alignment.
•
If necessary, prepare lifting platform.
•
Drive vehicle onto lifting platform.
Note: The front and rear wheels must be positioned centrally
on the rotary and sliding plates.
•
Remove locking pins from both rotary and sliding plates, align
pickup using bubble level and activate
RA KDS chassis/wheel alignment check with ride-height measurement without load
BMW AG - TIS
08.02.2013 03:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
