X Series E70 X5 4.8i (N62TU) OFFRD
Slacken nut (1) two to three thread turns.
If necessary, replace lower section 31 2 242 with lower
section 31 2 246 .
Press tie rod end (2) with special tool 31 2 240 off swivel
bearing.
Unscrew nut (1) and remove tie rod end (2) from swivel bearing.
Installation:
Keep tie rod end to swivel bearing connection clean and free from
oil and grease.
Replace self-locking nut.
Tightening torque 32 21 3AZ
.
Determine measurement (A) to simplify following adjustment of
front axle.
Slacken nut.
Unscrew tie rod end from tie rod.
Installation:
Check gaiter for damage, replace if necessary.
Refit clamping ring (1).
Screw tie rod end onto tie rod to measurement (A).
Tightening torque 32 21 2AZ
.
After installation:
•
Perform chassis alignment check
•
Carry out steering angle sensor adjustment/adjustment for
active front steering
RA Replacing left or right tie rod
BMW AG - TIS
08.02.2013 03:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
