X Series E70 X5 4.8i (N62TU) OFFRD
Tightening torque 32 21 1AZ
.
On replacement, assemble new part with gaiter:
•
Determine measurement (A) on old part to simplify following
adjustment of front axle
•
Slacken clamping nut (2)
•
Screw off tie rod end; if necessary, grip tie rod with open-end
wrench
•
Remove clamping ring (1) and screw off clamping nut (2)
•
Slide gaiter (4) and ear clamp and band clamp (3) onto tie
rod
•
Slide clamping nut (2) and clamping ring (1) onto tie rod
•
Screw tie rod end onto tie rod to measurement (A)
•
Tighten down clamping nut (2)
Tightening torque 32 21 2AZ
.
After installation:
•
Only if replacing/removing tie rod end: Perform chassis
alignment check
•
Carry out steering angle sensor adjustment/adjustment for
active front steering
RA Replacing (removing and installing) left or right tie rod
BMW AG - TIS
08.02.2013 03:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -