X Series E70 X5 4.8i (N62TU) OFFRD
34 51 527
Removing and installing or replacing DSC
hydraulic unit
Necessary preliminary tasks:
•
Read and comply with General Information.
•
Extract brake fluid
Note:
Extract brake fluid out of expansion tank. Use a suction bottle
used exclusively for drawing off brake fluid.
Do not reuse drawn out brake fluid.
After completing work:
•
Bleeding braking system
Important!
Do not mix up brake lines.
If necessary, mark before removal.
Brake lines must not be bent.
Close off connection bores with plugs.
Disconnect plug connection (1).
Unfasten brake lines (2).
Tightening torque 34 32 1AZ
.
If necessary, release brake lines from holder on bulkhead.
Unscrew bolt (3).
Tightening torque 34 51 6AZ
.
Pull hydraulic control unit with holder out of guide pins (4) and
remove.
RA Removing and installing or replacing DSC hydraulic unit
BMW AG - TIS
08.02.2013 05:20
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
