X Series E70 X5 4.8i (N62TU) OFFRD
34 35 001
Replacing a brake pad sensor (front)
Important!
The brake pad wear sensor must be replaced once it has
been removed (brake pad wear sensor loses its retention
capability in the brake pad).
If a brake pad sensor that has already been ground has to be
replaced even though the minimum brake pad thickness has
not yet been reached, you must observe the following: The
new sliding contact must be filed down with a file to the same
length as the ground sliding contact.
Necessary preliminary tasks:
•
Remove wheel
Disengage cable guides (2).
Open cover (1) on plug housing.
Disconnect plug connection.
Disengage cable from cable guide (3).
Pull brake pad sensor (1) in direction of arrow out of brake pad.
Installation:
Make sure brake pad sensor (1) is correctly seated in brake pad.
Disengage cable of brake pad sensor from holders (2).
RA Replacing a brake pad sensor (front)
BMW AG - TIS
08.02.2013 05:21
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
