X Series E70 X5 4.8i (N62TU) OFFRD
Important!
Rubber lips (1) must be correctly situated between retaining
brackets!
Installation:
Check anti-friction bearing (2) for damage; if necessary, replace
stabilizer (observe note at start of repair instruction).
Keep contact face for rubber mount on anti-friction bearing clean
and free from oil and grease.
Check rubber mount for damage, replace if necessary.
Important!
To remove the risk of mix-up after removal of the control lines
at the holders, observe the following:
-
Holder, left: Stud bolt (1) arranged virtually centrally on
the holder
-
Holder, right: Stud bolt (1) arranged more to the front of
the holder
-
Align holders as pictured by way of additional lugs (2);
both lugs point in direction of travel to right
After installation:
•
Fill and bleed hydraulic system
•
Check pipe connections for leaks
•
Carry out initial Dynamic Drive operation.
RA Removing and installing/replacing front active stabilizer
BMW AG - TIS
08.02.2013 05:52
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
