X Series E70 X5 4.8i (N62TU) OFFRD
Press air spring (1) upwards and turn through A = 30
°
in
counterclockwise direction.
Important!
Do not kink, twist or crush pipe.
Press air spring (1) together, remove sideways and set down on
guide arm.
Release banjo bolt (1).
Seal pipe (2) and connection of air spring with adhesive tape.
Note:
Banjo bolt (1) remains on pipe (2).
Important!
It is not permitted to cut open the protective gaiter to feed
through the pipe (with banjo bolt)!
Remove protective gaiter (1) from air spring.
Unclip pipe (2) from groove of air spring upper section and
remove air spring.
If reusing: check protective gaiter (1) for damage.
Note:
Protective gaiter (1) may be reinstalled in spite of expanded
opening (for pipe with banjo nut).
If protective gaiter is damaged: pull pipe (2) with banjo bolt
through opening in protective gaiter (1).
RA Removing and installing/replacing left or right air spring
BMW AG - TIS
08.02.2013 05:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
