X Series E70 X5 4.8i (N62TU) OFFRD
51 16 3..
Removing and installing/replacing hinge for
upper glovebox lid
Necessary preliminary tasks:
•
Remove glovebox
•
Remove upper glovebox lid
Close glovebox lid.
Release tab washer (1) and remove pin (2).
Open glovebox lid.
Disconnect spring (3).
Release screw (4).
Feed out damping element (5).
Installation:
Replace tab washer (1) and pin (2).
Release screws (1).
Take off holder (2).
Feed out hinge (3).
Installation:
Spring (1) must not be damaged.
If necessary, pull out shaft (2) and replace faulty bushings (4).
Markings (3) on bushing (4) and hinge must line up.
RA Removing and installing/replacing hinge for upper glovebox lid
BMW AG - TIS
08.02.2013 08:01
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
