X Series E70 X5 4.8i (N62TU) OFFRD
51 31 021
Removing and installing/replacing rubber
frame for windscreen (top)
Necessary preliminary tasks:
•
Remove both gutter strips on windscreen
Important!
Rubber frame (1) features an aluminium section inlay (3).
Carefully unwind rubber frame (1) (windscreen breakage).
Note:
Tear-off lip (2) can be stuck on adhesive.
When rubber frame (1) is removed, tear-off lip (2) can tear off
and remain in vehicle.
Replacement of rubber frame without windscreen removal:
There is no tear-off lip (4) and no butylene tape (3) in area (A).
Detach tear-off lip (4) from rubber frame (1).
If adhesive leaks over tear-off lip (4), this area must be cut out
partially.
To facilitate installation, coat rubber frame (1) and body cutout
with water.
Install rubber frame (1), paying attention to centre marking in so
doing.
2
Aluminium strip
3
Butylene tape
RA Removing and installing/replacing rubber frame for windscreen (top)
BMW AG - TIS
08.02.2013 08:52
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
