X Series E70 X5 4.8i (N62TU) OFFRD
67 62 020
Removing and installing/replacing flat motor
for rear left or right power window unit
Necessary preliminary tasks:
•
Remove rear power window unit
Release screws (1) and detach flat motor (2) from power
window unit.
Installation:
Retaining pins (3) must not be released!
Important!
To ensure tension-free installation of flat motor, observe the
specified screwing sequence.
Tighten first screw (1), then screw (2) and finally screw (3).
Tightening torque 67 62 1AZ
.
After installation:
A normalization must be carried out in order to activate anti-
trapping protection.
Normalization sequence:
•
Ensure adequate system voltage
•
All doors closed
•
Press correspond power window switch in "Close" position
and hold for approx. 2 seconds with window closed
Note:
RA Removing and installing/replacing flat motor for rear left or right power window
BMW AG - TIS
08.02.2013 18:01
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
