X Series E83 X3 2.0d (M47T2) OFFRD
Disconnect plug connection (1).
Release screws (2) and remove holder with DSC sensor.
Important!
Follow instructions on removing and installing DSC sensor.
Unclip mounting clip (1) upwards out of balance arm (2).
Guide handbrake Bowden cables (1) with a screwdriver inwards
and pull out of balance bar (2).
Disconnect cable (1) from handbrake check switch.
Release screw (2) and remove handbrake lever (3).
Installation:
Tightening torque 34 41 1AZ
.
Handbrake lever and adjustment unit (ASZE) are only exchanged
completely as a single unit.
RA Removing and installing (replacing) handbrake lever
BMW AG - TIS
04.02.2013 18:42
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
