X Series E83 X3 2.0d (N47) OFFRD
Remove front propeller shaft.
Release sealing cap in timing case from below.
Picture shows the sealing cap on the removed engine. Replace
sealing cap with O-ring.
Installation:
Tightening torque, 11 14 1AZ
Screw in special tool 11 8 741 for positioning sprocket wheel of
high-pressure pump. Then remove special tool 11 8 742 .
Special tool 11 8 741 remains in timing case
until end of repair
work.
Remove high-pressure pump support.
Release retaining screws on front of high-pressure pump.
Release mounting bolt (1) on side of timing case.
RA Removing and installing/replacing high-pressure pump (N47)
BMW AG - TIS
05.02.2013 22:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -