X Series E83 X3 2.0d (N47) OFFRD
27 21 010
Replacing radial shaft seal for drive flange
(ATC 400/500 X-Drive)
Special tools required:
•
23 0 490
•
27 1 390
Important!
After completion of work, check gear oil level and top up if
necessary.
Use only approved gear oil in this transfer box.
Necessary preliminary tasks:
•
Remove transfer box.
Drive a hole into radial shaft seal (2) using a center punch (1).
Important!
Do not use a drill as drillings may result in transmission
malfunction.
Note:
Illustration shows NV125 transmission
RA Replacing radial shaft seal for drive flange (ATC 400/500 X-Drive)
BMW AG - TIS
05.02.2013 23:58
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -