X Series E83 X3 2.0d (N47) OFFRD
Release nut; if necessary, grip brace at Torx socket.
Force tie rod end off swivel bearing with special tool 31 2 300 .
Installation:
Keep tie rod end to swivel bearing connection clean and free from
oil and grease.
Replace self-locking nut.
Tightening torque 32 21 3AZ
.
Determine measurement (A) to simplify following adjustment of
front axle.
Release clamping nut.
Screw off tie rod end; if necessary, grip tie rod with open-end
wrench.
Installation:
Check gaiter for damage, replace if necessary.
Mount clamping ring (1).
Screw tie rod end onto tie rod to measurement (A).
Tightening torque 32 21 5AZ
.
After installation:
•
Perform chassis alignment check
•
Carry out steering angle sensor adjustment
RA Replacing left or right tie rod
BMW AG - TIS
06.02.2013 00:49
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -