X Series E83 X3 2.0d (N47) OFFRD
32 32 170
Removing and installing/replacing interlock
cable
Necessary preliminary tasks:
•
Remove function carrier on trim for instrument panel
•
Remove lower section of steering column trim
After installation:
•
Check function of interlock cable.
•
Adjust interlock cable.
Release screw (1).
Take off holder (2).
Press interlock cable (3) in area of switch block to driver's side
and remove towards front.
Turn guide sleeve (1) through approx. 45
°
.
Pull interlock cable (2) out of steering column.
Tie wire or cord to end of interlock cable (1) in area of switch
block.
Pull out interlock cable (1) in direction of steering column.
Important!
Do not kink interlock cable (1).
If necessary, remove wire or cord from interlock cable (1).
Installation:
Check installation position of interlock cable (1) in area of footwell
heating duct (2), correct if necessary.
RA Removing and installing/replacing interlock cable
BMW AG - TIS
06.02.2013 01:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -