X Series E83 X3 2.0d (N47) OFFRD
Installation:
Markings (3) on suction line and vane pump connection must
match up.
Release screws (1, 2) and remove vane pump towards top.
Installation:
1.
Provisionally fasten vane pump with screws (1, 2) (do not
tighten down screws).
2.
Tighten first screw (2) and then screws (1) to 2 Nm
3.
Tighten down screws (1)
Tightening torque 32 41 1AZ
.
4.
Release screw (2) and check screw fastening point for gap
freedom
5.
Tighten down screw (2)
Tightening torque 32 41 1AZ
.
After installation:
•
Fill and bleed hydraulic system
•
Check pipe connections for leaks
RA Removing and installing (replacing) vane pump for power steering (N47)
BMW AG - TIS
06.02.2013 01:10
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -