X Series E83 X3 2.0d (N47) OFFRD
33 32 086
Removing and installing/replacing bottom left
control arm
Note:
If the lower control arm is detached from the rear axle
carrier/trailing arm, it is necessary after reinstallation to carry out a
wheel/chassis alignment check.
Necessary preliminary tasks:
•
Remove rear wheel.
•
Remove stabilizer from rear axle carrier
•
Support rear differential and remove from rear axle carrier
Important!
To avoid damaging the output shaft, it will be necessary to
support the trailing arm with the workshop jack.
Support trailing arm from underneath using a workshop jack.
Spread cover on lower control arm and pull off.
Installation:
Opening in cover points upwards.
Replace damaged cover.
Mark position of eccentric screw (1) to lower control arm with
centre marks (2).
Replacement only: Carry over marking from old part to new part.
RA Removing and installing/replacing bottom left control arm
BMW AG - TIS
06.02.2013 01:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -